INSTRUCTIONS FOR CUTTING WIRES COMPUTER NETWORK

INSTRUCTIONS FOR CUTTING WIRES COMPUTER NETWORK

PREPARE:

- 1 cable punches.

- 1 terminal block RJ45.

- The network cable (length according to your demand)

Currently there are two cable standards T568A click connect 2 computers together and T568B hub connecting two computers with cable press standards include:

- Press Straight: This type is used to connect two devices together kind. Example: PC + Switch, Switch + Router

RJ-45 JACK TIA / EIA 568A Standard called Standard A.

  T568A: 1. White 2. Green 3. Green 4. Blue 5. Orange White White White Blue 6. Orange 7. Brown 8. Brown

- Press the Cross: This type is used to connect two devices of the same type together. Example: PC-PC, PC-Router ...

RJ-45 JACK TIA / EIA 568B standard STANDARD called B.

T568B: 1. 2. Orange 3. White Orange White Green Blue 4. White 5. Blue 6. Green 7. White-brown 8. Brown.

INSTRUCTIONS FOR CUTTING WIRES COMPUTER NETWORK

Cross-cutting cables

Step 1: You use pliers or scissors to cut the cable casing: about 4 cm

Step 2  : Remove the head and twisted in order: White prearranged - Orange - Blue - Green - Brown.

Step 3  : Change the white spot of white, green and blue of each other.

Step 4 Put the wires back together and using pliers to cut close to equal.

Step 5 : Your conduct wire inserted into the deep end of the cable to the wire touches the copper core.

Step 6 : then inserted into alkaline and press hard

Cable Straight Way Press

- Cut the cable cover and place the order wire 1 -> 2 -> 3 -> 5 -> 6 -> 4 -> 7 -> 8.

- Ratings by police again and cut back just enough not to 1 segment with RJ45.

Then the remaining steps do similar press crossover cable.

INSTRUCTIONS FOR CUTTING WIRES COMPUTER NETWORK